OpenSSL Security Advisory [6 March 2019] ======================================== ChaCha20-Poly1305 with long nonces (CVE-2019-1543) ================================================== Severity: Low ChaCha20-Poly1305 is an AEAD cipher, and requires a unique nonce input for every encryption operation. RFC 7539 specifies that the nonce value (IV) should be 96 bits (12 bytes). OpenSSL allows a variable nonce length and front pads the nonce with 0 bytes if it is less than 12 bytes. However it also incorrectly allows a nonce to be set of up to 16 bytes. In this case only the last 12 bytes are significant and any additional leading bytes are ignored. It is a requirement of using this cipher that nonce values are unique. Messages encrypted using a reused nonce value are susceptible to serious confidentiality and integrity attacks. If an application changes the default nonce length to be longer than 12 bytes and then makes a change to the leading bytes of the nonce expecting the new value to be a new unique nonce then such an application could inadvertently encrypt messages with a reused nonce. Additionally the ignored bytes in a long nonce are not covered by the integrity guarantee of this cipher. Any application that relies on the integrity of these ignored leading bytes of a long nonce may be further affected. Any OpenSSL internal use of this cipher, including in SSL/TLS, is safe because no such use sets such a long nonce value. However user applications that use this cipher directly and set a non-default nonce length to be longer than 12 bytes may be vulnerable. OpenSSL versions 1.1.1 and 1.1.0 are affected by this issue. Due to the limited scope of affected deployments this has been assessed as low severity and therefore we are not creating new releases at this time. The 1.1.1 mitigation for this issue can be found in commit f426625b6a. The 1.1.0 mitigation for this issue can be found in commit ee22257b14. This issue does not impact OpenSSL 1.0.2. This issue was discovered by Joran Dirk Greef of Ronomon. The fix was developed by Matt Caswell from the OpenSSL development team. It was reported to OpenSSL on 26th February 2019. Note ==== OpenSSL 1.0.2 and 1.1.0 are currently only receiving security updates. Support for 1.0.2 will end on 31st December 2019. Support for 1.1.0 will end on 11th September 2019. Users of these versions should upgrade to OpenSSL 1.1.1. References ========== URL for this Security Advisory: https://www.openssl.org/news/secadv/20190306.txt Note: the online version of the advisory may be updated with additional details over time. For details of OpenSSL severity classifications please see: https://www.openssl.org/policies/secpolicy.html